Portable X Ray Machine
Product introduction:
This model combines the advantages of similar products found at home and abroad; it eliminates the shortcomings of the on-frequency X-ray machine (high current intensity and excess amounts of scrap x-rays).Using a Toshiba 0.3 micro-focus tube.The tube voltage frequency of this machine is 30 KHz，and the tube current is 1 MA. The radiation scope is at an angle of 24 degrees， located within a distance of 1.2 meters ahead. This is an innovative Chinese design named the "Green X-ray Machine."
TECHNICAL SPECIFICATIONS：
Tube Voltage | 65kv |
Tube Current | 1mA |
Time Exposure | 0.1~~1.8s |
High pressure generator | 30kHz DC |
Rated Power | 60w |
Focal Spot To Skin Distance | >20CM |
Focus Spot Size | 0.3mm(TOSHIBA) |
Charger Input Voltage | AC110V～220V |
Supply Frequency | 30Hz |
Radiation Leakage | <20ugy/h |
Battery | 24V DC 2600MA |
Weight | 2KG |
Dimensions | 37 cm×31 cm×28cm (L×W×H) |
Operation of the Main Unit :
Upon receiving，open the box and check the product for possible damage during shipping. Make sure the fittings on the encasement list are packaged within the box. Install the blue ray tube to the foreside of the ball head，then tighten it. Turn on the Power；the pilot lamp will be light up.During this time，the digital tube will show the fore setting time. Now the equipment is in standby mode. Setting the time (Skip to next step if unneeded) Use the "SET"，"+"，and" -" buttons to reset the time as follows: press SET，the pilot lamp above is illuminated， the machine is now in the time setting mode → then press "+" and" -" to set the time needed (time range is 1-9seconds); press set again when the time is adjusted the light lamp is off. The equipment is now in standby mode. Put the Tooth film plumb behind the tooth which is going to be taken picture， and be as close as possible (the smooth side stick to the tooth) Keep the ball head plumb to the tooth projection position; Have the ball head，tooth， and tooth film steadily mutually plumb. After positioning，use the ON/OFF on the main Unit， to take pictures. (Notice: gently press 0.5 sec to turn it on) After exposure to the tube，press the start button again in case of an emergency to stop shooting and return to standby status. (At this point there was no output ray，so the dental films can be used again). Repeat step 6 to reset the picturing time.To repeat the picturing process，please repeat steps 7 to 9. Turn the power off when the work is finished，press POWER， making sure the pilot lamp is off.Don't keep the machine long in standby mode
Hot Tags: portable x ray machine, China, suppliers, manufacturers, factory, low price
