1. Connect the power supply of the syringe pump to the 220V socket, and then turn on the power switch.
2. Select the syringe to be used (generally, the syringe pump should be able to use the syringe produced by any manufacturer), according to the specifications required by the syringe pump brand, use the syringe to extract the liquid and empty the air, and then lift the pressure handle of the syringe, Install it into the syringe retaining groove of the syringe pump. After the syringe is fixed, connect the corresponding catheter to the venous channel.
3. Set the injection procedure, including the injection volume and injection speed of the injected drug.
4. After the liquid storage is completed, press the start button to start the injection.
5. After completing the injection of the liquid medicine, pull out the needle, then turn off the power of the syringe pump, and wipe the syringe pump clean for next use.
Operating Precautions for Syringe Pump
1. If there is an alarm when the syringe pump is in use, it should be checked and eliminated in time. Common alarm conditions include pipeline blockage and liquid drain.
2. If you need to change the liquid medicine when using the syringe pump, you should first clamp the venous channel with clips, temporarily stop the operation of the syringe pump, and then take out the syringe. After the liquid medicine is replaced, put the syringe into the fixed groove again, repeat the steps of setting the injection procedure in the operation process, and then open the channel, and then start the syringe pump.
3. When using the syringe pump, the ambient temperature should be greater than 45°C, because the operation of the syringe pump is relatively stable at this temperature.
4. The setting range of the injection running rate of the syringe pump should generally be set at 0.1-100ml/h.
5. When installing the syringe, the rotating clip and sliding propeller should not be too forceful to prevent the liquid from entering the patient too much.
