Daily use and maintenance of C-arm
1. Release the foot brake, push the machine to the operating table, and adjust the operating table. The monitor is placed in a position facing the operator for easy viewing.
2. Connect the high-voltage cable between the operator and the monitor, and turn on the power. 3. Turn on the power switch on the control panel of the operator, and perform self-test.
4. Release the brake switch on the C-arm, adjust the C-arm so that the tube and receiver are aligned with the shooting position, and then lock the brake switch.
5. Select the perspective or film function on the control panel of the operator, and select the manual program or the automatic program to adjust the energy level.
6. The staff should wear protective equipment, prepare for protection, and choose a manual switch or a foot switch for discharging and filming.
7. If you want to print a picture, first select the picture you want to print on the display screen, and tap the print switch.
8. After the operation is completed, turn off the power switch on the control panel, unplug the power socket, and arrange the circuit.
9. Pull the operating machine out of the field of view, and separate the high-voltage cable from the operating machine and the display. Put the unit back and lock all brake switches.
daily maintenance
1. Regularly inspect the C-arm to ensure its use.
2. Be careful not to collide when moving the C-arm.
3. The C-arm support rod must be lowered to the lowest position after each use.
4. Push the C-arm back to its original position and lock the casters after use.
