maintenance:
1. After the daily operation, the flow sensor module and the patient's breathing circuit need to be removed for maintenance. It is recommended to use high temperature and high pressure to sterilize the silicone suction line.
2. Use neutral detergent to wipe the dirt on each surface of the host.
3. Use as many flow sensors as possible and replace them among different patients or during long-term operations to extend the life of the sensors. The flow sensor needs to be blown dry with a low-pressure flow of pure oxygen to keep it dry. If the flow sensor still does not work normally after removing the water, and the flow sensor is replaced, it means that the original flow sensor receiver needs to be scrapped.
Precautions:
1. The anesthesia machine should be used by a qualified anesthetist, and unqualified personnel are not allowed to operate it.
2. When various alarms occur, the reasons for the alarms should be analyzed. If the alarm caused by the malfunction of the anesthesia machine itself cannot be eliminated, the standby machine should be replaced immediately and the engineer should be notified for maintenance; if the alarm is caused by the patient's physiological parameter changes, the necessary measures should be taken immediately or shut down.
3. During the use of the anesthesia machine, without the consent of the anesthesiologist, other personnel cannot arbitrarily change the setting parameters and the upper and lower alarm limits.
